ADF document tray assembly removal
1 Remove the ADF front cover. Go to “ADF front cover removal” on page 537.
2 Remove the ADF rear cover. Go to “ADF rear cover removal” on page 538.
3 Remove the two metal screws (A) from the top of the ADF document tray assembly.
4 Slide the ADF document tray assembly to the right.
5 Disconnect the ADF paper length/width sensors cable.
6 Remove the ADF document tray assembly.
Installation note: When reinstalling the ADF document tray assembly, make sure to adjust the skew. Go to
“Adjusting skew” on page 291.
ADF top door assembly removal
1 Remove the ADF front cover. Go to “ADF front cover removal” on page 537.
2 Remove the ADF rear cover. Go to “ADF rear cover removal” on page 538.
3 Lift the ADF top door assembly.
4 Push down on the spring clips (A) on the left and right sides.
5 Remove the ADF left door links (B).
7462
Repair information
539
To Next Page
Loading...
