Lexmark 7462 series - USB Port <X> Disabled

56 USB port <x> disabled
<x> is the number of the USB port.
Try one or more of the following:
• Tou ch Continue to clear the message.
The printer discards any data received through the USB port.
• Make sure the USB Buer menu item is not set to Disabled.
57
Configuration
change, held jobs were not restored
Since the time the jobs were stored on the printer hard disk something has changed in the printer to
invalidate the held jobs. Possible changes include:
• The printer firmware has been updated.
• Paper input, output, or duplex options needed for the print job were removed.
• The print job was created using data from a device in the USB port and the device is no longer in the
port.
• The printer hard disk contains jobs that were stored while installed in a
dierent
printer model.
Tou ch Continue to clear the message.
58 Too many bins attached
1 Turn the printer power
o.
2 Unplug the power cord from the wall outlet.
3 Remove the additional bins.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer power back on.
58 Too many disks installed
1 Turn the printer
o.
2 Unplug the power cord from the wall outlet.
3 Remove the extra disks.
4 Connect the power cord to a properly grounded outlet.
5 Turn the printer back on.
58 Too many
flash
options installed
1 Turn the printer
o.
2 Unplug the power cord from the wall outlet.
3 Remove the excess
flash
memory.
7462
Diagnostic information
198