3 Select from the following options:
• ADF Front—Place the quick test page faceup, short edge first into the ADF.
• ADF Back—Place the quick test page facedown, short edge
first
into the ADF.
The current values of the horizontal adjust and top margin registration settings appear.
4 Adjust the value of the horizontal adjust and top margin settings.
5 Apply the changes.
6 Repeat step 2 to view the updated values.
7 Repeat steps 3 through 5 to make further adjustments.
Disable Scanner
Use this setting to disable the scanner if it is not working properly.
1 Enter the Configuration menu, and then select Disable Scanner.
2 Select a setting, and then apply the changes.
3 Reset the printer.
Paper Prompts
When the paper source (tray or feeder) is out of the indicated paper size, a prompt is sent to the user to load
the paper in the paper source. This setting allows you to assign a paper source with the correct size of paper
loaded.
1 From the Configuration menu, select Paper Prompts.
2 Select one of the following:
• Auto
Note: This is the factory default setting.
• MP Feeder or Multi‑Purpose Feeder (depending on your printer model)
• Manual Paper
3 Depending on your printer model, touch Submit or press the Select button to apply the changes.
Envelope Prompts
This setting allows you to assign a specific tray or feeder with a correct size of envelope loaded.
1 From the Configuration menu, select Env Prompts or Envelope Prompts depending on your printer model.
2 Select one of the following:
• Auto
Note: This is the factory default setting.
• MP Feeder
7462
Service menus
284
To Next Page
Loading...
