Lexmark 7462 series - ADF Solenoid Assembly Removal

ADF solenoid assembly removal
1 Remove the ADF front cover. Go to “ADF front cover removal” on page 537.
2 Remove the ADF pick roll position cam assembly spring from the cam shaft lever.
3 Disconnect the solenoid wire harness.
4 Remove the two screws securing the solenoid bracket assembly to the frame of the ADF unit assembly.
5 Remove the ADF solenoid assembly.
Sensor (ADF top door interlock) removal
1 Remove the ADF rear cover assembly. Go to “ADF rear cover removal” on page 538.
2 Remove the feed motor bracket assembly. Go to “ADF feed drive motor assembly removal” on page
551.
3 Disconnect the sensor harness from the sensor.
4 Remove the sensor (ADF top door interlock) bracket screw (A).
5 Remove the bracket with the sensor (ADF top door interlock).
6 Detach the sensor (ADF top door interlock) from the bracket by squeezing the clip (B)and removing the
sensor.
AB
Sensor (ADF lower door interlock) removal
1 Remove the ADF front cover. Go to “ADF front cover removal” on page 537.
2 Remove the ADF platen cushion. Go to “ADF platen cushion removal” on page 541.
7462
Repair information
554