Copy skew correction procedure
Note: This
specification
is used for copies from the
flatbed,
front ADF, and back ADF.
1 Check the paper squareness.
2 Make sure that the guides in the paper tray are properly aligned.
3 Check the base printer skew and registration.
4 Make sure that the page is pushed to the top left corner of the flatbed.
5 Make sure that the auto document guides are snug against the page.
6 Plug the printer into the power source, and then power on in Normal Printing Mode.
7 Measure CopyL1, CopyL2, CopyT1, CopyT2, CopyR1, CopyR2, CopyB1, and CopyB2 data points as shown
below.
CopyT1
CopyL1
CopyT2
CopyR1
CopyB1
CopyL2
CopyB2
CopyR2
8 Measure from the edge of the paper to the outer edge of the thick black line.
9 Determine the following calculations:
• CopyL2‑CopyL1 = ____
• CopyR2‑CopyR1 = ____
• CopyT2‑CopyT1 = ____
• CopyB2‑CopyB1 = ____
• CopyT1‑CopyB1 = ____
• CopyL1‑CopyR1 = ____
10 Determine if the printer passes or fails the skew specifications based on the values listed on the table.
7462
Repair information
301
To Next Page
Loading...
