Lexmark 7462 series - Page 300

5 Measure L1, L2, T1, T2, R1, R2, B1, and B2 data points as shown below.
T1
L1
T2
R1
B2
R2
B1
L2
6 Determine the following calculations:
• L2‑L1 = ____
• R2‑R1 = ____
• T2‑T1 = ____
• B2‑B1 = ____
7 Determine if the printer passes or fails the skew specifications based on the values listed on the table.
Specifications
‑‑ (L2‑L1) (R2‑R1) (T2‑T1) (B2‑B1)
Letter equal or less than 1.4 mm equal or less than 1.4 mm equal or less than 1 mm equal or less than 1 mm
A4 equal or less than 1.5 mm equal or less than 1.5 mm equal or less than 1 mm equal or less than 1 mm
Legal equal or less than 1.8 mm equal or less than 1.8 mm equal or less than 1 mm equal or less than 1 mm
8 If the printer does not meet the skew specifications, then adjust the reference edge.
9 Check the registration by looking at the dots and the edges of the page. Adjust as neede.
7462
Repair information
300