• Tou ch Finish job without further scanning if page jam recovery is active. The job ends at the last
successfully scanned page, but the job is not canceled. Successfully scanned pages go to their
destination: copy, fax, e-mail, or FTP.
• Tou ch Restart job if job recovery is active. The message clears. A new scan job containing the same
parameters as the previous job starts.
Replace wiper
Replace the fuser wiper, or try one or more of the following:
• Tou ch Continue to clear the message and continue printing.
• Tou ch Ignore to clear the message, but at the next power-on, the message appears again.
Restore Held Jobs?
Try one or more of the following:
• Tou ch Continue to restore all held jobs stored on the printer hard disk.
• Tou ch Do not restore if you do not want any print jobs to be restored.
Scan Document Too Long
The scan job exceeds the maximum number of pages. Touch Cancel Job to clear the message.
Scanner ADF Cover Open
The ADF cover is open. The message clears when the cover is closed.
Scanner Jam Access Cover Open
Close the bottom ADF door to clear the message.
Securely clearing disk space
The printer hard disk wiping process needs to recover. The message clears when all blocks are cleared.
Sending page <n>
The printer sends page <n> of the fax job, where <n> is the number of the page sent. Wait for the message
to clear.
Serial <x>
The printer is using a serial cable connection. The serial port is the active communication link.
7462
Diagnostic information
192
To Next Page
Loading...
