ADF unit assembly removal (model X658)
1 Remove the scanner rear cover. Go to “Scanner rear cover removal” on page 522.
2 Remove the scanner left support cover. Go to “Scanner support left cover removal (model X658)” on
page 514.
3 Disconnect the CCD harness and ground strap from behind the scanner left support cover.
4 Disconnect the CCD harness and ground strap from behind the scanner rear cover.
5 Open the ADF.
6 Remove the two thumb screws (A) on both sides of the ADF unit.
A
7 Slide the ADF unit to the rear, lift up, and remove the ADF unit assembly.
Installation note: When reinstalling the ADF unit assembly, make sure to adjust the skew. Go to
“Adjusting
skew” on page 291.
ADF left hinge removal
1 Remove the ADF unit assembly. Go to “ADF unit assembly removal (models X651, X652, X654, and X656)”
on page 560 or “ADF unit assembly removal (model X658)” on page 561..
2 Remove the ADF feed motor bracket assembly with cable. Go to “ADF feed drive motor assembly removal”
on page 551.
7462
Repair information
561
To Next Page
Loading...
