Lexmark 7462 series - Fax Failed; Fax Memory Full; Fax Partition Inoperative. Contact System Administrator; Fax Server To Format Not Set Up. Contact System Administrator

Tou ch Continue to clear the message.
Fax failed
The fax failed to be sent. Wait for the message to clear.
Fax memory full
There is not enough memory to send the fax job.
Tou ch Continue to clear the message.
Fax partition inoperative. Contact system administrator.
The fax partition appears to be corrupted. Try one or more of the following:
• Tou ch Continue to clear the message.
• Turn the printer o and then back on to reset the printer. If the message appears again, then contact
your system support person.
Fax server 'To Format' not set up. Contact system administrator.
The printer is in Fax Server mode, but the Fax Server setup has not been completed.
Try one or more of the following:
• Tou ch Continue to clear the message.
• Complete the Fax Server setup. If the message appears again, contact your system support person.
Fax Station Name not set up
The Fax Station Name has not been entered. Sending and receiving faxes is disabled until fax is configured
properly.
Try one or more of the following:
• Tou ch Continue to clear the message.
• Complete the Analog Fax Setup. If the message appears again, contact your system support person.
Fax Station Number not set up
The Fax Station Number has not been entered. Sending and receiving faxes is disabled until fax is configured
properly.
Try one or more of the following:
• Tou ch Continue to clear the message.
• Complete the Analog Fax Setup. If the message appears again, contact your system support person.
Flushing
buer
Wait for the message to clear.
7462
Diagnostic information
186