Output expander controller card cover panel removal
1 Remove the output expander media output bin assembly. Go to “Output expander media output bin
assembly removal” on page 476.
2 Remove the screw (A) on the back side of the option.
A
3 Remove the grounding screw (B) on the right output option frame guide the grounding cable through the
hole in the frame.
4 Carefully flex the panel from the lower middle and pull the four tab (C) out of the frame and remove.
Output expander controller card removal
1 Remove the output expander controller card cover panel. Go to “Output expander controller card cover
panel removal” on page 480.
2 Disconnect all harnesses from the controller card.
7462
Repair information
480
To Next Page
Loading...
