Sensor (standard exit bin) actuator assembly removal
1 Open the upper rear door.
2 Remove the fuser access panel.
3 Remove the redrive assembly. Go to “Redrive assembly removal” on page 374.
4 Using a flat‑blade screwdriver, press on the tab (A) securing the sensor (standard exit bin) actuator assembly.
A
5 Position the sensor (standard exit bin) actuator assembly where the laser can be removed.
6 Remove the laser cover. Go to “Laser cover removal (model X658)” on page 327.
7 Remove the sensor (standard exit bin) actuator assembly.
7462
Repair information
384
To Next Page
Loading...
