Sensor (MFP stapler assembly media in stapler) removal
1 Remove the stapler unit assembly. Go to “MFP stapler assembly stapler unit assembly removal” on
page 494.
2 Using a flat-blade screwdriver, release the tabs (A) securing the sensor.
A
3 Using needlenose pliers, carefully grip the sensor and pull it out and disconnect the harness.
Installation note: Using needlenose pliers, place the rear most tab in the sensor bracket first. Then push
on the rear face of the sensor until the other two tabs snap into place.
7462
Repair information
502
To Next Page
Loading...
