INPUT TRAY TESTS
Feed Tests (input tray)
This test feeds blank pages through the paper path. This runs using any supported paper or envelope sizes.
1 From the Diagnostics menu, navigate to INPUT TRAY TESTS > Feed Tests.
2 Select a paper source, and then select one of the following:
• Single—This feeds a single page.
• Continuous—This continuously feeds pages until the Stop button is pressed.
Sensor Test (input tray)
This determines whether the input tray sensors are working correctly.
1 From the Diagnostics menu, navigate to INPUT TRAY TESTS > Sensor Test.
2 Select a paper source.
Note: Only installed paper sources are listed in the menu.
3 Select a sensor to test.
Sensors available for each paper source
Paper source Tray empty sensor Paper low sensor Pass through sensor
Tray 1
X
Tray 2
Tray 3
Tray 4
Tray 5
Multipurpose feeder
XX
Envelope feeder
XX
4 Manually actuate each sensor to make it toggle between Open and Closed. The tray empty sensor can be
actuated by hand. Use a sheet of paper to cover the pass through sensor.
Note: If the sensor does not toggle, then it is malfunctioning.
5 Press the Stop button to exit the test.
OUTPUT BIN TESTS
Feed Tests (output bins)
This test
verifies
whether the media can be fed to a
specific
output bin. No information is printed on the media.
This test can use any media size or envelope supported by the printer.
7462
Service menus
270
To Next Page
Loading...
