Lexmark 7462 series - Scanner Reference LED Cable Assembly Removal

6 Remove the scanner exposure lamp wiring harness from the clips (D) on the CCD assembly.
D
C
7 Remove the scanner exposure lamp by lifting up on the rear end and pulling the lamp out of the grommet.
Scanner reference LED cable assembly removal
1 Remove the scanner platen glass cover assembly. Go to “Scanner platen glass cover assembly removal
(models X651, X652, X654, and X656)” on page 527 or “Scanner platen glass cover assembly removal
(model X658)” on page 527.
2 Remove the screw (A) securing the scanner reference LED cable assembly to the flatbed frame.
A
3 Remove the scanner reference LED cable assembly.
4 Remove the wire harness from the scanner reference LED cable assembly.
7462
Repair information
507