Lexmark 7462 series - Invalid Refill, Change Cartridge

30 Invalid refill, change cartridge
Remove the print cartridge, and then install a supported one.
31 Replace defective cartridge
Remove the defective print cartridge, and then install a new one.
32 Cartridge part number unsupported by device
Remove the print cartridge, and then install a supported one.
34 Short paper
Try one or more of the following:
• Load the appropriate paper or other specialty media in the proper tray.
• Tou ch Continue to clear the message and print the job using a dierent paper tray.
• Check tray length and width guides and make sure the paper is properly loaded in the tray.
• Check the Print Properties or Print dialog settings to make sure the print job is requesting the correct
paper size and type.
• Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, make
sure the paper is large enough for the data being printed.
• Cancel the current print job.
35 Insucient memory to support Resource Save feature
Try one or more of the following:
• Tou ch Continue to disable Resource Save and continue printing.
• To enable Resource Save after receiving this message, make sure the link buers are set to Auto, and
then exit the menus to activate the link buer changes. When Ready appears, enable Resource Save.
• Install additional memory.
37
Insucient
memory to collate job
Try one or more of the following:
• Tou ch Continue to print the portion of the job already stored and begin collating the rest of the print
job.
• Cancel the current print job.
37
Insucient
memory for Flash Memory Defragment operation
Try one or more of the following:
• Tou ch Continue to stop the defragment operation and continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
7462
Diagnostic information
194