4 Disconnect the connector (B) from the MPF lower deflector assembly.
A
B
C
5 Remove the MPF lift plate assembly.
Installation warning: When replacing the MPF lift plate assembly, ensure that the lever (C) is held down
when reinstalling the MPF lift plate assembly, or damage will occur.
Installation warning: When replacing the MPF lift plate assembly, ensure that the MPF pick solenoid
assembly does not become damaged.
MPF media out actuator removal
1 Remove the media turn guide. Go to “Media turn guide removal” on page 338.
2 Gently unsnap the MPF media out actuator from the machine.
3 Remove the media out actuator.
MPF pick roll assembly removal
1 Remove the media turn guide. Go to “Media turn guide removal” on page 338.
2 Remove the E-clip (A) securing the MPF print roll assembly to the machine.
7462
Repair information
339
To Next Page
Loading...
