Lexmark 7462 series - Offset Stacker Tamper Drive Belt Removal

Oset stacker tamper drive belt removal
1 Remove the
oset
stacker tamper recoil spring.
2 Pull the belt out the tamper belt holder and remove the belt from the pulley.
Oset
stacker tamper drive motor assembly removal
1 Remove the oset stacker top cover. Go to “MFP stapler assembly top cover removal” on page 450.
2 Pull slack in the tamper drive belt and remove the belt from the tamper drive belt pulley.
3 Disconnect the tamper driver motor harness from the controller card.
7462
Repair information
455