3 Close the operator panel door assembly.
4 Remove the four screws (A) securing the main drive motor assembly to the machine.
5 Gently remove the main drive motor assembly.
6 Disconnect the connection (B) from the main drive motor assembly.
A B
Installation warning: Ensure that all electrical connections are properly replaced.
Installation warning: When replacing the main drive motor assembly, ensure that the operator panel
door assembly is in the closed position or the main drive motor assembly will not align properly and
damage will occur.
Installation warning: When replacing the main drive motor assembly, ensure that all gears and drive
shafts are properly aligned, or damage will occur.
MPF pick solenoid assembly removal
Note: The MPF lift plate assembly can be detached and allowed to hang by the harness. The connection
does not need to be disconnected.
1 Remove the MPF lift plate assembly. Go to “MPF lift plate assembly removal” on page 338.
2 Remove the left side cover. Go to “Left side cover removal (models X651, X652, X654, and X656)” on
page 317 or “Left side cover removal (model X658)” on page 318.
7462
Repair information
313
To Next Page
Loading...
