Output cover assembly removal (model X658)
1 Open the rear door assembly.
2 Lift the right side of the fuser exit access panel and remove.
Printhead assembly removal
Warning—Potential Damage: When replacing the printhead assembly, ensure that the printhead skew is
properly adjusted, or print quality issues will occur. Go to
“Alignment assembly adjustment” on page 305.
1 Remove the laser cover. Go to “Laser cover removal (models X651, X652, X654, and X656)” on
page 325 or “Laser cover removal (model X658)” on page 327.
2 Remove the six screws (A) securing the metal cover to the machine.
A
A
3 Remove the metal cover.
7462
Repair information
377
To Next Page
Loading...
