Installation warning: When reinstalling the transfer roll bracket assembly, left, ensure that the bushing
(C), spring (D), and ground wire (F) are properly replaced.
Right transfer roll bracket assembly removal
1 Remove the transfer roll assembly. Go to “Transfer roll assembly removal” on page 351.
2 Remove the inner deflector. Go to “Inner deflector removal” on page 337.
3 Remove the screw (A) securing the transfer roll bracket assembly, right to the machine.
A
4 Remove the transfer roll bracket assembly, right.
Transfer deflector removal
1 Remove the transfer roll assembly. Go to “Transfer roll assembly removal” on page 351.
2 Gently unsnap the transfer deflector from the machine.
3 Remove the transfer
deflector.
7462
Repair information
353
To Next Page
Loading...
