Sensor (pass through) with cable removal
1 Remove the 250-sheet frame assembly. Go to “250-sheet tray frame assembly removal” on page 406.
2 Disconnect the sensor (pass through) cable connector from the 250-sheet controller card.
3 Remove the sensor (pass through) with cable.
Sensor (pass through) with cable removal
1 Remove the 550-sheet frame assembly. Go to “550-sheet tray frame assembly removal” on page 411.
2 Disconnect the sensor (pass through) cable connector from the 550-sheet controller card.
3 Remove the sensor (pass through) with cable.
7462
Repair information
471
To Next Page
Loading...
