Stapler/stacker controller card assembly removal
1 Remove the left cover. Go to “MFP stapler assembly left cover removal” on page 486.
2 Disconnect all harnesses to the controller card.
3 Remove the three screws (A) securing the stapler/stacker controller card assembly.
A
4 Remove the stapler/stacker controller card assembly.
Scanner removals
Scanner CCD assembly removal
CAUTION—POTENTIAL INJURY: When you see this symbol, there is a danger from hazardous voltage
in the area of the product where you are working. Unplug the product before you begin, or use caution if
the product must receive power in order to perform the task.
1 Remove the scanner platen glass cover assembly. Go to “Scanner platen glass cover assembly removal
(models X651, X652, X654, and X656)” on page 527 or “Scanner platen glass cover assembly removal
(model X658)” on page 527.
2 Loosen the screw (A) on the carriage belt tensioner.
7462
Repair information
504
To Next Page
Loading...
