Lexmark 7462 series - Wipe Disk

Wipe Disk
This setting allows you to erase the contents of the hard disk.
1 From the Configuration menu, select Wipe Disk.
2 To uc h Wipe disk now, and then touch Ye s to continue.
Note: Erased data is unrecoverable.
Font Sharpening
Note: This is not supported when the device generates an output at 600 dpi resolution.
This setting allows you to set a text point-size value below which the high‑frequency screens are used when
printing font data.
1 From the Configuration menu, select Font Sharpening.
2 Increase or decrease the value.
Notes:
• The values for this setting range from 0 to 150. 24 is the factory default setting.
• This setting aects PostScript, PCL, and XL.
3 Depending on your printer mode, touch Submit or press the Select button to apply the changes.
Require Standby
This setting allows you to enable the Standby Mode.
1 Enter the Configuration menu, and then select Require Standby.
2 Select a setting.
3 Apply the changes.
LES Applications
Note: This setting is for touch-screen models only.
This setting allows you to enable or disable Lexmark Embedded Solutions (LES) applications. This setting does
not
aect
built‑in applications.
1 From the Configuration menu, select LES Applications.
2 Select Enable or Disable.
Note: Enable is the factory default setting.
3 Depending on your printer model, touch Submit or press the Select button to apply the changes.
7462
Service menus
286