Lexmark 7462 series - Page 203

Error code Description Action
51 The printer detects a defective flash. Go to
“Defective or full Flash service check” on
page 208.
52 The printer detects an unformatted flash at
power on.
Go to
“Defective or full Flash service check” on
page 208.
54A A serial error (framing, parity, or overrun) has
been detected on the specified serial port. This
usually indicates that the serial port has not been
set up correctly.
Go to
“Network service check” on page 208.
54B The standard network port is detected, but the
printer cannot establish communications with it.
Go to
“Network software eror service check” on
page 208.
54C An optional network port is detected, but the
printer cannot establish communications with it.
Go to
“Network software eror service check” on
page 208.
55B An unsupported option is installed in the
specified solutions port.
Go to
“Unsupported Option in Slot [x] service
check” on page 211.
56A The parallel port or serial port is disabled. Go to
“Network service check” on page 208.
56B The standard or optional USB port is disabled. Go to
“Network software eror service check” on
page 208.
56C Optional input trays installed above the RFID
option or no input trays installed
Go to
“Standard USB port dsabled” on
page 211.
58A Excess bins detected. Go to
“Too Many Bins Attached service check”
on page 211.
58B Excess disks detected. Go to
“Too Many Disks Attached service check”
on page 211.
58C Excess flash options detected. Go to
“Too Many Flash Options service check”
on page 212.
58D Excess trays detected. Go to
“Too Many Trays Attached service check”
on page 212.
59 The duplex option is incompatible. Go to
“Incompatible Duplex service check” on
page 212.
59 The envelope feeder is incompatible. Go to
“Incompatible Duplex service check” on
page 212.
59 The output bin is incompatible. Go to
“Incompatible Output Bin [x] service
check” on page 213.
59 The tray is incompatible. Go to
“Incompatible Output Tray [x] service
check” on page 213.
61 The hard disk is defective. Go to
“Defective Disk service check” on
page 213.
62 The hard disk is full. Go to
“Disk Full service check” on page 213.
80 The printer requires maintenance. The
appropriate maintenance kit needs to be
installed.
Go to
“Routine Maintenance Needed service
check” on page 214.
7462
Diagnostic information
203