3 Back the reference adjustment screw out far enough to allow the alignment assembly to be removed from
the printer. It is not necessary to completely remove the screw.
Allen wrench
4 Install the new alignment assembly. Turn the reference screw clockwise with a 7 mm M3 Allen wrench until
it touches the back of the reference plate, and tighten the nut with a 5.5 mm wrench.
The reference adjustment screw can be adjusted without loosening the nut. Turn the screw clockwise a few
turns and print a copy of the Quick Test Page as you check the diamonds on the left margin. Continue adjusting
the screw as you check the results of each adjustment on a new test page until you obtain the results you want.
Step B
Print a copy of the Quick Test Page and check the margin adjustments printed on the test page. These settings
should be within the range specified in
“Registration” on page 263. The reference screw can be adjusted
without loosening the locknut. Turn the screw a few turns, and print a copy of the Quick Test Page as you check
the diamonds on the left margin. Continue adjusting the screw as you check the results of each adjustment on
a new test page until you obtain the results you want.
7462
Repair information
306
To Next Page
Loading...
