3 Remove the three screws (B) securing the operator panel assembly bottom to the scanner frame.
B
4 Remove the cover strip (C) from the operator panel assembly.
5 Remove the three screws (D) securing the operator panel assembly.
6 Slide the operator panel assembly to the left.
7 Rotate the operator panel assembly upside down, and remove the three screws (E).
C
D
E
8 Separate the lower panel from the upper panel.
9 Disconnect the operator panel and cave light harnesses.
10 Remove the operator panel assembly.
7462
Repair information
350
To Next Page
Loading...
