6 Remove the two screws (D) securing the ground straps to the either side of the scanner frame.
D
D
B
B
C
Note: Remove the ground strap to prevent damage to the surface which the scanner is placed on.
7 Push the flatbed toward the rear of the cover.
8 Lift and remove the scanner support platform.
9 If the scanner support platform needs to be removed from the printer, remove the four mounting screws as
outlined in the scanner unit assembly removal. Go to
“Scanner unit assembly removal (models X651, X652,
X654, and X656)” on page 531.
7462
Repair information
530
To Next Page
Loading...
