EasyManua.ls Logo

Lexmark 7462 series - Page 594

Lexmark 7462 series
729 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Assembly 10: Flatbed scanner
Asm-index P/N Units/mach Units/FRU Description Removal procedure
1 40X6393 1 1 Scanner LED assembly (X651, X652, X654,
and X656)
--
1 40X6394 1 1 Scanner LED assembly (X658) --
2 40X2642 1 1 Scanner platen glass cover assembly --
3 40X4530 1 1 Scanner FB length sensor cable assembly --
4 40X6396 1 1 Scanner LED module --
5 40X4534 1 1 Sensor (platen glass length) assembly --
6 40X2641 1 1 Flatbed scanner interface card cable (X651,
X652, X654, and X656)
--
6 40X4533 1 1 Flatbed scanner interface card cable
(X658)
--
7 40X4523 1 1 Carriage belt --
8 40X2171 1 1 Scanner interface card assembly --
9 40X4521 1 1 Carriage drive motor assembly with cable --
10 40X4528 1 1 Scanner reference LED cable assembly --
11 40X4532 1 1 Scanner reference LED assembly --
12 40X4524 1 1 Sensor (scanner HP) with bracket --
13 40X4529 1 1 Scanner HP sensor cable assembly --
14 40X4522 1 1 Carriage belt tensioner assembly --
15 40X4535 1 1 Scanner cooling fan --
16 40X4536 1 1 Scanner cooling fan filter --
17 40X7204 1 1 Scanner filter cover --
18 40X4531 1 1 Scanner CCD ribbon cable (X658) --
18 40X2172 1 1 Scanner CCD ribbon cable (X651, X652,
X654, and X656)
--
Warning—Potential Damage: Only replace one component at a time, when replacing any of these
components ‑‑ Scanner interface card assembly, system card assembly, and scanner unit assembly. Replace
the required component and perform a POR before replacing a second component listed above. If this
procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the
components listed above without a POR after installing each one or the printer will be rendered inoperable.
These components can be used as a method of troubleshooting as long as the machine is booted into
diagnostic mode or is operating in diagnostic mode. Once a component has been installed in a machine and
powered up into user mode, it cannot be used in another machine. It must be returned to the manufacturer.
7462
Parts catalog
594

Table of Contents

Related product manuals