Panasonic KX-TD816 - Charge Rate Assignment

2.2 System Programming
General Programming 115
[142] Charge Rate Assignment
Description
Assigns the rate to each outside line.
Selection
• Outside line number:
KX-TD816 –
01 through 08,
KX-TD1232 –
01 through 24,
( =all outside lines)
• Desired number:
10 digits max.
(including the decimal point)
Default
All outside lines – 0.00
Programming
1.
Enter
142
.
Display: 142 CHARGE RATE
2.
Press
NEXT
.
Display: CO Line NO?
3.
Enter an
outside line number
.
To enter outside line number 01, you can also press
NEXT
.
Display example: CO01: 0.00
4.
Enter a
charge rate
.
To delete the current entry, press
CLEAR
.
To change the current entry, press
CLEAR
and enter the new rate.
To enter a decimal point, press the key.
5.
Press
STORE
.
6.
To programme another outside line, press
NEXT
or
PREV
, or
SELECT
and the desired
outside line number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• For the KX-TD1232, outside lines 01 through 12 are for the Master System and outside
lines 13 through 24 are for the Slave, if available.
• To assign all outside lines to the same selection, press the key in step 3. In this case, the
display shows the contents programmed for outside line 01.