2.6 COS Programming
238 General Programming
[510] Night Service Access
Description
Enables or disables switching the Day / Night service on a Class of Service (COS) basis.
Selection
• COS number:
1 through 8,
( =all COS)
•
Enable / Disable
Default
All COS – Disable
Programming
1.
Enter
510.
Display: 510 NITE SERVICE
2.
Press
NEXT.
Display: COS NO?
3.
Enter a
COS number.
To enter COS number 1, you can also press
NEXT.
Display example: COS1:Disable
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another COS, press
NEXT
or
PREV,
or
SELECT
and the desired
COS
number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• To assign all COS to one selection, press the key in step 3. In this case, the display shows
the contents programmed for COS 1.
• The operator extension can switch the mode regardless of setting.
Features Guide References
Day / Night Service
To Next Page
Loading...
