Panasonic KX-TD816 - DID; TIE Wink Time out Assignment

2.5 Outside Line Programming
General Programming 205
[435] DID / TIE Wink Time Out Assignment
Description
The DID / TIE outgoing method can be set to the wink mode in programme [432] DID / TIE
Outgoing Assignment. This programme sets the time the system waits for the confirmation
wink signal after an outside line is seized according to your central office service.
Selection
• DID / TIE format number:
1 through 8,
( =all DID / TIE formats)
•Time:
1 through 127
( 64 milliseconds is the actual time)
Default
All DID / TIE formats – 16
Programming
1.
Enter
435.
Display: 435 WINK TIMEOUT
2.
Press
NEXT.
Display: Format NO?
3.
Enter a
DID / TIE format number.
To enter DID / TIE format number 1, you can also press
NEXT.
Display example: 1:16
4.
Enter the
time.
To change the current entry, press
CLEAR
and enter the new number.
5.
Press
STORE.
6.
To programme another DID / TIE format, press
NEXT
or
PREV,
or
SELECT
and the
desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• You cannot leave the entry empty.
• To assign all DID / TIE formats to one selection, press the key in step 3. In this case, the
display shows the contents programmed for DID / TIE format number 1.
Features Guide References
Direct Inward Dialling (DID)