2.6 COS Programming
General Programming 239
[511] PT Programming Level
Description
Determines the Station Programming level on a Class of Service (COS) basis. There are two
levels as follows.
Level 1
: enables all Station Programming.
Level 2
: disables CO button programming in Station Programming.
Selection
• COS number:
1 through 8,
( =all COS)
•
LVL 1 / LVL 2
Default
All COS – LVL1
Programming
1.
Enter
511.
Display: 511 PITS PGM LVL
2.
Press
NEXT.
Display: COS NO?
3.
Enter a
COS number.
To enter COS number 1, you can also press
NEXT.
Display example: COS1:LVL1
4.
Keep pressing
SELECT
until the desired selection is displayed.
Display example: COS1:LVL2
5.
Press
STORE.
6.
To programme another COS, press
NEXT
or
PREV,
or
SELECT
and the desired
COS
number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• If you try to execute the CO button programming while on level 2, a warning tone is heard
and the initial programming display appears.
• A ringer frequency for each CO button cannot be changed on level 2.
• The programming assigned on [005] Flexible CO Button Assignment can be overwritten,
regardless of the level of this programming.
To Next Page
Loading...
