Panasonic KX-TD816 - CPC Signal Detection Outgoing Set

2.5 Outside Line Programming
General Programming 193
[415] CPC Signal Detection Outgoing Set
Description
Enables or disables Calling Party Control (CPC) Signal Detection during the time between the
originated outside call and the established outside call. If this is enabled, the system
disconnects the line with the time set in programme [405] CPC Signal Detection Incoming Set
when the CPC Signal is detected.
Selection
• Outside line (CO) number:
KX-TD816 –
01 through 08,
KX-TD1232 –
01 through 24,
( =all outside lines)
•
Enable
(detection) /
Disable
(no detection)
Default
Disable
Programming
1.
Enter
415
.
Display: 415 CPC OUTGOING
2.
Press
NEXT
.
Display: CO Line NO?
3.
Enter an
outside line number
.
To enter outside line number 01, you can also press
NEXT
.
Display example: CO01:Disable
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another outside line, press
NEXT
or
PREV,
or
SELECT
and the desired
outside line number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• Some central offices (CO) may send CPC-like signals during the dialling sequence and an
attempt to make a call may be terminated. If your CO is such a type, select "Disable".
• Programme [405] CPC Signal Detection Incoming Set is used to set CPC Signal Detection
Time.