2.2 System Programming
General Programming 73
[113] VM Status DTMF Set
Description
Sets the DTMF (Dual Tone Multi-Frequency) signals transmitted to your Voice Processing
System (VPS) to inform the VPS of the VPS ports states quickly:
The following signals are sent to the VPS with the assigned DTMF signals:
RBT
(ringback tone):
This signal is sent when calling an extension.
BT
(busy tone):
This is sent when the called extension is busy.
ROT
(reorder tone):
This is sent when the dialled number is invalid.
DND
(DND tone):
This is sent when the other extension has DND assigned.
Answer
:
This is sent when the other extension answers the call.
Disconnect
:
This is sent when the other extension hangs up.
Confirm
(confirmation tone):
This is sent when the feature number for "Message Waiting Lamp" is valid.
FWD VM RBT
(FWD to VM ringback tone):
Not available (reserved).
FWD VM BT
(FWD to VM busy tone):
This is sent when the called extension has set Call Forwarding to VPS.
FWD EXT RBT
(FWD to extension ringback tone):
Not available (reserved).
Selection
•
RBT / BT / ROT / DND / Answer / Disconnect / Confirm / FWD VM RBT /
FWD VM BT / FWD EXT RBT
• DTMF signal number:
3 digits (max.)
Default
RBT – 1; BT – 2; ROT – 3; DND – 4; Answer – 5; Disconnect – #9; Confirm – 9;
FWD VM RBT – 6; FWD VM BT – 7; FWD EXT RBT – 8
Programming
1.
Enter
113.
Display: 113 VM DTMF CMD
2.
Press
NEXT
to programme ringback tone status.
To programme another status, keep pressing
NEXT
until the desired status is displayed.
To Next Page
Loading...
