2.5 Outside Line Programming
General Programming 173
[402] Dial Mode Selection
Description
Each outside line can be programmed for DTMF (Dual Tone Multi-Frequency), pulse (rotary)
or call blocking. This programme assigns your choice to each line.
DTMF:
The dialling signals from an extension, either tone or pulse, are converted to tone signals and
transmitted to the outside line.
Pulse:
The dialling signals from an extension, either tone or pulse, are converted to pulse signals and
transmitted to the outside line.
Call blocking:
If your central office can receive both DTMF and pulse signals but you are contracted for pulse,
select this mode. When dialling on the line with a touch tone telephone, only the pulse signals
are sent to the outside line.
Selection
• Outside line (CO) number:
KX-TD816 –
01 through 08
,
KX-TD1232 –
01 through 24
,
( =all outside lines)
•
DTMF / Pulse / C. Block
(call blocking)
Default
KX-TD816BX, KX-TD1232(D)BX/ML, KX-TDN1232: All outside lines – Pulse
KX-TD816HK, KX-TD1232HK/X: All outside lines – DTMF
Programming
1.
Enter
402
.
Display: 402 DIAL MODE
2.
Press
NEXT
.
Display: CO Line NO?
3.
Enter an
outside line number
.
To enter outside line number 01, you can also press
NEXT
.
Display example: CO01:Pulse
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another outside line, press
NEXT
or
PREV
, or
SELECT
and the desired
outside line number
.
7.
Repeat steps 4 through 6.
To Next Page
Loading...
