2.6 COS Programming
230 General Programming
[503] Call Transfer to Outside Line
Description
Determines which Classes of Services (COS) are allowed to perform the Call Transfer to
Outside Line function.
Selection
• COS number:
1 through 8,
( =all COS)
•
Enable / Disable
Default
All COS – Disable
Programming
1.
Enter
503.
Display: 503 CALL XFER CO
2.
Press
NEXT.
Display: COS NO?
3.
Enter a
COS number.
To enter COS number 1, you can also press
NEXT.
Display example: COS1:Disable
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another COS, press
NEXT
or
PREV,
or
SELECT
and the desired
COS
number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• To assign all COS to one selection, press the key in step 3. In this case, the display shows
the contents programmed for COS 1.
Features Guide References
Call Transfer
To Next Page
Loading...
