2.8 Resource Programming
General Programming 281
[816] SMDR Output Mode
Description
Assigns the SMDR output mode. There are two standards available – Regular and Charge.
Selection
Regular / Charge
Default
Regular
Programming
1.
Enter
816
.
Display: 816 SMDR MODE
2.
Press
NEXT
.
Display example: SMDR:Regular
3.
Keep pressing
SELECT
until the desired selection is displayed.
4.
Press
STORE
.
5.
Press
END
.
Conditions
• Select the output mode used by your SMDR.
• If you assign for Charge, you can select the display in Meter / in Charge through programme
[143] Charge Display Selection.
• When "Charge" is selected, the assignment in programme [990] System Additional
Information, Area 05 - bit 12, is ignored and "<I> + caller no." is printed out in the SMDR.
Features Guide References
Station Message Detail Recording (SMDR)
To Next Page
Loading...
