4.4 E1 Line Programming
E1 Programming 357
[741] E1 Dial Mode
Description
Assigns a dial type to each E1 channel.
For DR2 channel, only the dial sending mode can be assigned in this programme. For dial
receiving mode, the assignment in programme [745] E1 DR2 Receiver is activated.
For the other channels, the assignment in this programme is used for both the dial sending and
receiving mode.
This programme is available for the KX-TD1232 only.
Selection
• E1 channel number:
01 through 30
, ( =All E1 channels)
• Signal type:
Pulse-10 / Pulse-20 / DTMF-80 / DTMF-160 / MFC-R2
Default
All E1 channels – Pulse-10
Programming
1.
Enter
741
.
Display: 741 E1 DIAL MODE
2.
Press
NEXT
.
Display: CH NO?
3.
Enter a
channel number
.
To enter a channel number 01, you can also press
NEXT
.
Display example: CH01:Pulse-10
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE
.
6.
To programme another channel, press
NEXT
or
PREV
, or
SELECT
and the desired
channel number
.
7.
Repeat steps 4 through 6.
8.
Press
END
.
Conditions
• Adjust to a setting of the connected telephone company.
• To assign all channels to one selection, press the key in step 3. In this case, the display
shows the contents programmed for channel 01.
To Next Page
Loading...
