Panasonic KX-TD816 - Programming Methods

1.3 Programming Methods
Programming Instructions 15
1.3 Programming Methods
Advancing to the next stage
When "
SYS-PGM NO?
" is displayed, you can select one of the following:
• To go to programme [000], press the
NEXT
button.
• To go to another programme, enter the 3-digit programme address.
Rotation of jack number
Each jack of the Digital Super Hybrid System supports the connection of a digital proprietary
telephone and a single line device with different extension numbers (eXtra Device Port: XDP
function). To programme this function it is necessary to assign two parts for each jack. The first
part of jack one is 01-1. The second part of jack one is 01-2. The first part of jack two is 02-1
and so on. The
NEXT
and
PREV
buttons can be used to move from jack to jack as required.
Example
Note
The first part of a jack is for a DPT of a XDP-assigned jack. The second part is for a single line
device. Programme [600] EXtra Device Port assigns which jacks are XDP.
Storing your data
Press
STORE
to store your data.
•The
STORE
indicator lights red and a confirmation tone is emitted.
* Confirmation tone (one beep)
After pressing
STORE
, you will hear a beep. This informs you that storage is completed.
* Alarm tone (three beeps)
If you hear this alarm, your entry is not valid.
Making another selection within the same programme address
• To make the next higher selection, press
NEXT.
• To make the previous selection, press
PREV.
• To make a specific selection, press
SELECT
and then enter the number.
#01-1
NEXT
PREV
#01-2
NEXT
PREV
#02-1 #02-2......
NEXT
PREV