1.3 Programming Methods
16 Programming Instructions
Going to another programme address
After pressing
STORE,
you can go to another programme with either of the following two
methods:
a)
To go to the next larger programme address:
Press
Soft 1
(
SKP+
) or
VOLUME
(DOWN)
or rotate the
Jog Dial
in the counter-
clockwise direction.
To go to the next smaller programme address:
Press
SHIFT + Soft 1
(
SKP–
) or
VOLUME
(UP)
or rotate the
Jog Dial
in the
clockwise direction.
b)
To go to a specific programme address:
Press
END,
then enter the programme Address.
Method (1) is useful when you want to perform a series of programmes consecutively. For
example, to change the programming in addresses [0XX], use this method. You can move from
[000] to [001], from [001] to [002], and so on by pressing the
SKP+
or
VOLUME
. You can
move in reverse order from [008] to [007], etc. by pressing the
SKP–
or
VOLUME
.
This method can also be used to move between neighboring programme groups: For example,
you can move between the programme addresses of the largest [0XX] and [100], the largest
[1XX] and [200], and so on. Also, you can move between the smallest programme address
[000] and the largest one [9XX].
Method (2) is useful when you wish to jump to another programme address. For example, you
have just finished with programme [006] and now you want to go to programme [301]. Neither
SKP+
/
VOLUME
nor
SKP–
/
VOLUME
is convenient in this case. So you should press
END
and enter 301.
Note
The following programming instructions assume that you have already entered the
programming mode and that you will use Method (b).
Confirming the entries
You may review the stored programming without making any changes.
Going back to the operation mode
Two ways are available to go back to the operation mode:
a)
Lift the handset while in programming mode.
b)
When the Initial Message:
SYS-PGM NO?
is displayed, press the
PROGRAM (or
PAUSE)
button. (To display the Initial Message, press
END.
)
To Next Page
Loading...
