2.3 Timer Programming
General Programming 133
[207] First Digit Time
Description
Sets the maximum time allowed between the start of an outside dial tone and the first digit
dialled on an outgoing outside call. If an extension user fails to dial any digits during this time,
the DTMF (Dual Tone Multi-Frequency) receiver is released.
Selection
Time (seconds):
5 through 120
Default
10 s
Programming
1.
Enter
207
.
Display: 207 1ST DIGIT T
2.
Press
NEXT
.
Display example: Time: 10 sec
3.
Enter the
time
.
To change the current entry, press
CLEAR
and enter the new time.
4.
Press
STORE
.
5.
Press
END
.
Conditions
• This timer is used for toll restriction checking.
• You cannot leave the entry empty.
Features Guide References
Toll Restriction
To Next Page
Loading...
