Panasonic KX-TD816 - User Programming Mode

1.5 User Programming
22 Programming Instructions
1.5 User Programming Mode
User Programming Mode
Manager programming items (programme address: [0XX]) are accessible by any display
proprietary telephone user in the system.
Entering the user programming mode
You can access these programmes by entering the User Programming Mode as follows:
Before entering the mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone
After entering the mode, perform the same programming steps as the system programming
steps in each programme address.
Note
• If your telephone set does not have a
PROGRAM
button, substitute it with the
PAUSE
button.
• If nothing is entered in five seconds after the
PROGRAM
(or
PAUSE
) button is pressed, it
is cancelled.
• The User Password is not shown on the display. The password can be changed by system
programming. Refer to Section 2.2 [120] User Password.
• During the programming mode, your extension is treated as a busy extension.
• Only one proprietary telephone can be in programming mode at any one time.
Press PROGRAM (or PAUSE) + + and enter the User
Password (default=1234)