2.5 Outside Line Programming
General Programming 201
[432] DID / TIE Outgoing Assignment
Description
Assigns a DID and TIE outgoing method, immediate or wink, to each DID / TIE format
according to your central office service.
Immediate:
Outgoing DID and TIE numbers can be transmitted right after seizing the outside
line.
Wink:
Outgoing DID and TIE numbers can be transmitted after receiving the wink signal from
the central office after seizing the outside line.
Selection
• DID / TIE format number:
1 through 8,
( =all DID / TIE formats)
•
Immediate / Wink
Default
All DID / TIE formats – Wink
Programming
1.
Enter
432.
Display: 432 SIGNAL OUT
2.
Press
NEXT.
Display: Format NO?
3.
Enter a
DID / TIE format number.
To enter DID / TIE format number 1, you can also press
NEXT.
Display example: 1:Wink
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another DID / TIE format, press
NEXT
or
PREV,
or
SELECT
and the
desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• The time the system waits for the confirmation wink signal can be programmed in
programme [435] DID / TIE Wink Time Out Assignment.
The system disconnects the outside line when the time-out time expires.
• To assign all DID / TIE formats to one selection, press the key in step 3.
In this case, the display shows the contents programmed for DID / TIE format number 1.
To Next Page
Loading...
