2.5 Outside Line Programming
General Programming 187
[411] Host PBX Access Codes
Description
Assigns Host PBX access codes. If the system is installed behind a host PBX, an access code
is required to make an outside call. Up to four codes can be stored for an outside line group
assigned to the line.
Selection
• Outside line group (TRG) number:
1 through 8,
( =all outside line groups)
• Access code:
1 or 2 digits, four different entries (max.)
Default
All outside line groups – Not stored
Programming
1.
Enter
411
.
Display: 411 HOST PBX #'S
2.
Press
NEXT
.
Display: TRK GRP NO?
3.
Enter an
outside line group number
.
To enter outside line group number 1, you can also press
NEXT
.
Display example: TRG1: , , ,
4.
Enter an
access code
.
To delete the current entry, press
CLEAR.
To change the current entry, press
CLEAR
and enter the new access code.
Display example: TRG1:01, , ,
5.
To enter more access codes for the same outside line group, press and enter the
access
codes
until all the required entries are completed.
Display example: TRG1:01,08,10,22
6.
Press
STORE
.
7.
To programme another outside line group, press
NEXT
or
PREV,
or
SELECT
and the
desired
outside line group number
.
8.
Repeat steps 4 through 7.
9.
Press
END
.
Conditions
• This programme is only required if a host PBX line is connected to the system. Programme
[401] Outside Line Group Assignment is used to assign the line to an outside line group.
To Next Page
Loading...
