2.5 Outside Line Programming
General Programming 189
[412] Pause Time
Description
Assigns the length of the pause time. The programmed pause time is automatically inserted
after a line access number or a host PBX access code programmed in [411] Host PBX Access
Codes or manually inserted if the
PAUSE
button is pressed by the user.
Selection
• Outside line group (TRG) number:
1 through 8,
( =all outside line groups)
• Time (seconds):
1.5 / 2.5 / 3.5 / 4.5
Default
All outside line groups – 1.5 s
Programming
1.
Enter
412.
Display: 412 PAUSE TIME
2.
Press
NEXT.
Display: TRK GRP NO?
3.
Enter an
outside line group number.
To enter outside line group number 1, you can also press
NEXT.
Display example: TRG1:1.5sec
4.
Keep pressing
SELECT
until the desired time is displayed.
5.
Press
STORE.
6.
To programme another outside line group, press
NEXT
or
PREV,
or
SELECT
and the
desired
outside line group number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
• To assign all outside line groups to one selection, press the key in step 3. In this case, the
display shows the contents programmed for outside line group 1.
• Programme [401] Outside Line Group Assignment is used to assign each outside line to
an outside line group.
Features Guide References
Host PBX Access
Pause Insertion, Automatic
To Next Page
Loading...
