1.2 Using Proprietary Telephones
14 Programming Instructions
Before entering the programming mode
Before entering programming mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone.
Entering the programming mode
• The display shows the Initial Message:
SYG-PGM NO?
Note
• If your telephone set does not have a
PROGRAM
button, substitute it with the
PAUSE
button.
• If nothing is entered in five seconds after the
PROGRAM
(or
PAUSE
) button is pressed, it
is cancelled.
• The System Password entered is not shown on the display. The System Password can be
changed by System Programming. Refer to Section 2.2 [107] System Password.
• During the programming mode, your extension is treated as a busy extension.
• Only one proprietary telephone can be in programming mode at any one time.
Press PROGRAM (or PAUSE) + + # and enter your System
Password (default=1234).
To Next Page
Loading...
