1.2 Using Proprietary Telephones
12 Programming Instructions
You can use either the soft buttons or the overlay buttons. (For overlay buttons, refer to "Using
the Overlay" below.)
Throughout programming you will see instructions such as "Press
PREV
". If you use soft
buttons, this means press
SHIFT
, release
SHIFT
and then press
Soft 3
. The (PREV) function
is performed.
Note
If you use soft buttons and if programming instructions tell you to press the following buttons,
you may press soft buttons shown below.
Using the Overlay
A programming overlay is packed with the telephone at the factory. This overlay should be
used at all times while in programming mode since the functions of the telephone keys change
while in programming mode as follows: (The original functions are in parentheses.)
Instructions Soft button
SELECT
SEL+
,
SEL-
, or
SEL
CLEAR
CLR
During Normal Operation During Programming
(PAUSE) PAUSE / PROGRAM
(SP-PHONE) NEXT
(REDIAL) PREV (PREVIOUS)
(AUTO ANSWER / MUTE) SELECT
(FLASH) FLASH
(TRANSFER) CLEAR
(FWD/DND)
(CONF)
— /
(INTERCOM) SECRET
(AUTO DIAL / STORE) STORE
(HOLD) END
To Next Page
Loading...
