2.1 Manager Programming
General Programming 31
Conditions
• Each speed dial number has a maximum of 24 digits. The valid characters are
0 through 9,
the and
#
keys, and the
FLASH, PAUSE, SECRET
and
– (hyphen)
buttons.
– To store a flash signal, press
FLASH.
Note:
The stored flash will only be effective during a call. (Refer to External Feature Access
in the Features Guide.)
– To store a hyphen, press the "–" button.
– To store a pause, press
PAUSE.
(Refer to Pause Insertion, Automatic in the
Features Guide.)
– To store a feature number to convert pulse signals to DTMF (Dual Tone Multi-Frequency)
signals, press the and
#
keys.
(Refer to Pulse to Tone Conversion in the Features Guide.)
– To prevent displaying of all or part of the number, press
SECRET
before and after the
secret number. (Secret Dialling)
• If you are storing an external number, include the line access number (default: 9/0, 81
through 88) before the number. When dialling, a pause is automatically inserted after the
line access number.
• If you are storing an account code, enter the account code before the line access number.
(Refer to Account Code Entry in the Features Guide.)
• If you are storing a number for Incoming Outside Call Information Display with name,
enter "–" (hyphen) after the line access number. The system starts to compare the calling
party's number or called party's number with the System Speed Dialling number stored after
"–".
Example: 9 – 12345678
(Refer to Incoming Outside Call Information Display in the Features Guide.)
• A number consisting of 25 digits or more can be stored by storing it in two speed dial
numbers. The line access number should be stored in the first speed dial number.
• To access another speed dial number in step 6, press
SELECT
and start with step 3.
• To display parts of the number which have scrolled off the display, press or .
• Programme [002] System Speed Dialling Name Set is used to name the speed dial
numbers.
Features Guide References
Call Directory
System Speed Dialling
To Next Page
Loading...
