2.1 Manager Programming
52 General Programming
8.
To programme another user code, press
NEXT
or
PREV,
or
SELECT
and the desired
DISA / TIE user code number.
9.
Repeat steps 4 through 8.
10.
Press
END.
Conditions
• This setting is required if Trunk (Outside line) Security mode is selected in programmes
[439] TIE Security Type and [809] DISA Security Type.
• Each code should be unique and composed of four through ten numerical digits,
0 through
9.
• You cannot leave an entry empty.
Features Guide References
Direct Inward System Access (DISA)
TIE Line Service
To Next Page
Loading...
