Operation
R-Concept
140 / 564
Red warning indicators
Security code active Engine oil level too low
Coolant temperature too high Brake-air pressure brake reservoir
too low
Stop! Insufficient supply pressure Battery voltage too low or too high
(under 24V or over 32V)
Automated engine STOP active Release pressure parking brake
too low
WARNING! Injury hazard Defoliator shaft/lifter main drive
overloaded
Engine oil temperature too high Emergency stop switch pressed
Warning emergency steering
defect
Control Error memory engine
Coupling pressure of multiple disc
clutch CVR gearbox too low!
Lubrication CVR gearbox failed!
Drive motor 3 not at a standstill CVR gearbox coupling slips
Temperature in CVR gearbox is
too high!
TR5 reduction gears lubrication
failed!
Temperature in TR5 reduction
gears too high!
Red warning indicators of electronic problems
Rpm signal out of range Error data backup
Analogue signal out of range Incorrect machine configuration
Line break or short circuit found Communication problem with con-
trol device A15
Internal memory fault in EEPROM
To Next Page
Loading...